Products
Carrying Case / Mounting Rack
This is a case for housing DA/DC series single channel dynamic srtainmetrers for constituting multi-channel measurement system. The case has power switch, calibration signal switch and balancing button for operating all the channels at the same time.
Carrying Case
For configuration of multi-channel system with DA and DC series
These carrying cases are used to configure multi-channel system
with DA series, and DC series units. Each is equipped with a power
switch for simultaneous ON/OFF of all channels, a calibration strain
generation switch, and a balance button.
| Type | Capacity | Dimensions (mm) |
|---|---|---|
| P-4A | 4-ch | 208(W)×148(H)×308(D) |
| P-6A | 6-ch | 288(W)×148(H)×308(D) |
| P-8A | 8-ch | 368(W)×148(H)×308(D) |
| P-10A | 10-ch | 448(W)×148(H)×308(D) |
DA-17A/DA-37A Computer Control Carrying Case
This is a case for constituting multi-channel system wiith DA-17A/DA-37A series dynamic strainmeters. Setting of gain, lowpass filter, etc., initial-balancing, calibration strain generation and obtention of the set values and monitor values are possible through LAN interface from a computer. In addition, like the conventional case, power switch, calibration strain generation switch and balancing button for simultaneous operation of all channels are provided. The carrying case is for 4, 6, 8 and 10 channels.
| Type | Capacity | Dimensions (mm) |
|---|---|---|
| P-4AL | 4-ch | 208(W)×148(H)×308(D) |
| P-6AL | 6-ch | 288(W)×148(H)×308(D) |
| P-8AL | 8-ch | 368(W)×148(H)×308(D) |
| P-10AL | 10-ch | 448(W)×148(H)×308(D) |
Mounting Rack
JIS rack to configure a system with up to 10 units DA or DC series
This rack lets you configure a system with up to 10 channels using
DA series, or DC series units. It is equipped with a power switch for
simultaneous ON/OFF of all channels, a calibraiton strain generation
switch, and a balance button.
| Type | Capacity | Dimensions (mm) |
|---|---|---|
| R-10A | 10-ch | 480(W)×149(H)×311(D) |
Fixing Stand
For single use of DA and DC series and SA-22D. The stand is placed under the bottom panel.
One-touch Terminal SB-OT1A
The SB-OT1A is a terminal for binding leadwires by spring pressing. It can be mounted on the input terminal board of TML switching boxes and bridge boxes (SB-120SB, SB-121A, SB-122A). One terminal is needed for one leadwire. To be ordered every 5 pieces.
